Never attempt to use a regular auger bit on the drill press or in the hand drill. Auger bits for this machine have the lead screw cut smooth and the square tang cut off.
Clamp small pieces in a drill vise or clamp them to the table.
Keep the table clean, but clean it with a brush.
Wear a shop cap or tie up the hair when working around whirling machinery. Rings, wristwatches, and gloves should not be worn.
Check to see that the chuck key, drift, and all wrenches are removed before starting the machine.
Be certain your drills are ground in balance so that they do not tend to whip the work.
Beware of the coasting machine.
In using a shaping or routing attachment for the drill press, be sure to study the safety rules for the shaper.
On deep cuts back out frequently to clean and cool the bit.
Center punch for drill point. Use only straight sharp drills.