Pre-Professional Transfer Program in Engineering

Students may complete a one-year Engineering Transfer Program with full transfer to the University of Alberta Bachelor of Science in Engineering degree program.

a.Engineering (University of Alberta)

12 courses (34.5 credit hours) at the University of Lethbridge

University of transfer: Alberta

Required courses:

Chemistry 1000 - General Chemistry I

Chemistry 2000 - General Chemistry II

Computer Science 1620 - Fundamentals of Programming I

Engineering 1100 - The Engineering Profession (1.5 credit hours)

Engineering 1600 - Introduction to Engineering Design, Communication, and Profession

Engineering 2000 - Engineering Statics

Engineering 2060 - Engineering Mechanics

Mathematics 1410 - Elementary Linear Algebra

Mathematics 1565 - Accelerated Calculus I 

Mathematics 2565 - Accelerated Calculus II

Physics 2130 - Waves, Optics and Sound

Writing 1200 - Writing for Engineering Students

A minimum GPA of 2.50 is required for admission into the second year of Engineering at the University of Alberta. Students presenting a GPA lower than 2.50 may be offered admission based on available seats. Students are expected to complete the required 12 courses in two successive terms.

For detailed information about the Engineering program at the University of Alberta, and planning the University of Lethbridge program in order to meet those requirements, students are directed to the Program Planning Enclosure for Engineering (Alberta).